Histogram Range


  • Where to find it:


    • Add Adjustment Layer / Extension Pack / Histogram / 


    • NodeGraph / Right Mouse Click / Nodes / Filter / Extension Pack / Histogram / 


  • Shotcut (Nodegraph Only): Shift + H




The Histogram Range Node allows you to adjust the range and position of the input histogram.

It acts like its counterpart in Substance Designer.


Video


Node Overview




Node Ports

  • Range

Defines the width/range of the histogram.

If the value is over 1.0 some values might get pushed below 0.


Overwrites Range Slider if mapped


  • Position

Defines the mid point position of the histogram


Overwrites Position Slider if mapped


  • Mask

Optional Mask to limit the effect



Node Properties


MAIN TAB


  • Range

Defines the width/range of the histogram.

If the value is over 1.0 some values might get pushed below 0.


  • Position

Defines the mid point position of the histogram




  • Clamp Intermediary

Clamps the internal calculation of the node to 0-1.


To understand better what this does think of the Node like a condensed Levels or Set Range Node.

The Clamp Intermediary will clamp the output of the first part of the calculation - the 'Input' Levels (on a levels node)

or 'Old Minimum' and 'Old Maximum' values (on a Set Range Node) to 0-1. 



  • Clamp Output

Clamps the Output of the node to a 0-1 range



  • Mask Intensity

Control the intensity of the effect.

If a Mask it attached to the Mask port of the node this will control the intensity of the supplied mask